SPD's 304 stainless high performance resonator cat-back pipe replaces your factory resonator pipe wi.. SPD's high performance stage 2 resonator cat-back pipe replaces your factory resonator pipe with a t.. We have redesigned our GX Series catback systems and will have them available to ship at the end of .. The exhaust system is one of the most important parts of any vehicle. It protects the driver and other nearby cars almost as much as the braking system does. If you want your car to take care of you, you need to take the best care of it.
Beyond these incremental advantages, there’s not much to tell cat-back and regular exhausts apart, as they are commonly made from the same types of materials in roughly the same shape. Most newer vehicles have electronic fuel injection systems, and do not require air injection systems in their exhausts. Instead, they provide a precisely controlled air-fuel mixture that quickly and continually cycles between lean and rich combustion. Depending on your make and model, cat back exhaust systems can lead to an increase in fuel economy. The engine doesn’t have to work as hard pushing exhaust gases through the piping which reduces its load and leads to higher efficiency and MPG. For car enthusiasts and performance drivers, upgrading the exhaust system of a vehicle is a no-brainer.
Namely, it replaces the rear axle-back and tips and then a portion of what we refer to as the mid-pipes. This system is emissions friendly and doesn’t require any tuning. In New Jersey, vehicles must pass emissions testing to ensure they meet environmental standards. Since cat-back exhaust systems do not modify the catalytic converter or engine management system, they generally do not affect a vehicle’s ability to pass emissions testing.
It is important to note, however, that going too large may cause a dip in performance when gases pile up and exit the system slower resulting in torque, rpm, and horsepower loss. After the emissions are channeled out from the cylinders by the exhaust manifold, they are deposited into different catalytic converters. The IE Catback Exhaust System for your Audi B9/B9.5 S4 incorporates our in-house engineered DroneTrap technology to deliver a truly aggressive exhaust note without any annoying drone or rasp. Engineered with cutting-edge design features, including mandrel-bent stainless steel, TIG welding, multi-point reinforcements, and oversized quad tips. A catback exhaust system is a type of aftermarket exhaust system that replaces the muffler and tailpipe of a vehicle. It is called a "catback" system because it starts at the catalytic converter, which is located in the middle of the...
Engines fitted with regulated 3-way catalytic converters are equipped with a computerized closed-loop feedback fuel injection system using one or more oxygen sensors (also known as Lambda Sonds or sensors). Other variants combined three-way converters with carburetors equipped with feedback mixture control were used. An unregulated three-way converter features the same chemical processes but without the oxygen sensor, which meant higher NOx emissions, particularly under partial loads. These were low-cost solutions, typically used for retrofitting to older cars or for smaller, cheaper cars. Axle-back exhaust systems replace only your vehicle’s rear exhaust section, usually consisting of items behind the rear axles, like rear exhaust pipes, muffler, and exhaust tips. A